Subscriber Line - H3C MSR 20-20 Command Reference Manual

View
Parameter
Description
Example

subscriber line

Syntax
View
Parameter
undo special-character character number
R2 CAS view
character: Special character, which can be a pound sign (#) or asterisk (*), A, B, C,
or D.
number: Code of register signal, in the range 11 to 16.
Use the
special-character
acceptable during register signal exchange.
Use the
undo special-character
characters.
By default, no special characters are configured.
This command applies to R2 signaling only.
You may need to configure this command to accommodate to some national R2
signaling variants where Group I forward signals can represent special characters
such as pound signs (#) and asterisks (*) in addition to digits.
n
You cannot use the special-character command to assign a special character
■
different signal values.
To ensure that the device can process calls correctly, assign special characters
■
different signal values.
# Assign the pound sign (#) the register signal code 11.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] special-character # 11
subscriber line slot-number:{ ts-set-number | 15 | 23 }
Voice view
slot-number: Number of the voice subscriber line automatically created upon
creation of a TS group or ISDN PRI set.
ts-set-number: Number of the TS group that has been created.
15: Indicates the subscriber line is created for the ISDN PRI set created on an E1
interface.
command to configure the special characters
command to remove the configured special
2669