Gw-Id - H3C MSR 20-20 Command Reference Manual

2696 C 177: H.323 C
HAPTER
View
Parameter
Description
Related command:
Example

gw-id

Syntax
View
Parameter
Description
C
ONFIGURATION OMMANDS
undo gw-address
Gatekeeper client view
ip-address: Source IP address to be bound to the voice gateway.
Use the gw-address
gateway.
Use the
undo gw-address
By default, no source IP address is bound to the voice gateway.
c
CAUTION:
Use this command before configuring the ras-on command. In case the latter
■
has been configured, undo it first.
To make calls successfully, ensure that the source IP address is a valid IP address
■
already assigned to an Ethernet or loopback interface on the device, and in
addition, this address and the address of the peer H.323 entity (a gatekeeper,
terminal, or MCU) are reachable to each other.
area-id, gk-2nd-id, gk-id, gw-address, and ras-on.
# Bind the source IP address 1.1.1.1 to the voice gateway.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] gk-client
[Sysname-voice-gk] gw-address 1.1.1.1
gw-id namestring
undo gw-id
Gatekeeper client view
namestring: Gateway alias (gateway identifier), a string of 1 to 128 case-sensitive
characters.
Use the
gw-id
the old one, if any.
Use the
undo gw-id
By default, no alias is assigned to the gateway.
Note that each gateway can be assigned only one alias. It is used by the
gatekeeper to identify the gateway.
command to bind a source IP address with the voice
command to remove the binding.
command to assign an alias to the gateway. This alias overwrites
command to remove the alias.