Display Voice Default All - H3C MSR 20-20 Command Reference Manual

display voice default all

Syntax
View
Parameter
Description
Table 676 Description on fields of the display voice cmc command
Field
GblCallID
CalledAddr
CalledAddrSubst
CallerAddr
CallerAddrSubst
CallInfoTabIndex
Call Leg Number
Active Service
Spl Protocol
LocalRef
IfIndex
IpAddress
IpPort
LegState
ConnectState
SETUP message
SETUP_ACK message
ALERTING message
CONNECT message
RELEASE message
RELEASE_COMP message
INFORMATION message
SWITCH_CODEC message
FAXVOC_SWTH message
FAXVOC_SWTHACK message
display voice default all
Any view
None
Use the
display voice default all
and the system-fixed default values for voice and fax. For example, truncated
called number is used according to the default settings and system-fixed default
settings.
For example, the carrier transmission energy level of GW defaults to 10 (the
system-fixed default value is 15).
Description
Indicates the global ID of the call.
Indicates the called number of the call.
Indicates the called number after substitution
Indicates the caller number of the call.
Indicates the caller number after substitution
Indicates the call information index of the call.
Indicates the number of call legs of the call
Indicates the number of services involved in the call
Indicates the type of protocol used in the call leg
Indicates the local call identifier of the call leg.
Indicates the voice interface index connected to the call leg
Indicates the IP address connected to the call leg
Indicates the port number connected to the call leg
Indicates the state of the call leg
Indicates the state of connection of the call
Statistics of SETUP message
Statistics of SETUP_ACK message
Statistics of ALERTING message
Statistics of CONNECT message
Statistics of RELEASE message
Statistics of RELEASE_COMP message
Statistics of INFORMATION message
Statistics of SWITCH_CODEC message
Statistics of FAXVOC_SWTH message
Statistics of FAXVOC_SWTHACK message
command to view the current default values
2579