Ipx Route Max-Reserve-Path; Ipx Sap Disable - H3C MSR 20-20 Command Reference Manual

2544 C 172: IPX C
HAPTER
Description
Example

ipx route max-reserve-path

Syntax
View
Parameter
Description
Example

ipx sap disable

Syntax
C
ONFIGURATION OMMANDS
Use the ipx route load-balance-path
number of equivalent routes to the same destination.
Use the
undo ipx route load-balance-path
The default is 1.
This number is the maximum active equivalent route number of the system. If a
newly configured number is smaller than the previous, the system will change the
excessive active routes to inactive routes.
# Specify the maximum equivalent route number to the same destination address
as 30.
<Sysname> system-view
[Sysname] ipx route load-balance-path 30
ipx route max-reserve-path paths
undo ipx route max-reserve-path
System view
paths: Maximum number of routes to the same destination, including both static
and dynamic routes, in the range 1 to 255.
Use the
ipx route max-reserve-path
number of routes to the same destination.
Use the undo ipx route max-reserve-path
By default, the value is 4.
When the route number to the same destination address exceeds the maximum
value configured, the newly found dynamic routes will not be added into the
routing table, but discarded directly. If the newly configured value is less than the
original one, the excessive routes in the current routing table will not be deleted
until they get aged out or are deleted manually.
# Specify the maximum number of routes to the same destination to 200.
<Sysname> system-view
[Sysname] ipx route max-reserve-path 200
ipx sap disable
undo ipx sap disable
command to specify the maximum
command to restore the default.
command to specify the maximum
command to restore the default.