Display Voice Fax - H3C MSR 20-20 Command Reference Manual

2680 C 176: F
HAPTER AX OVER
Description
Example

display voice fax

Syntax
View
IP C C
ONFIGURATION OMMANDS
local-train threshold threshold: Specifies the threshold percentage of fax local
training (in the range of 0 to 100). The default value is 10.
nsf-on: Enables NSF message transmission. It is disabled by default.
protocol: Specifies the transport protocol of the fax. By default, the T.38 fax
protocol is applied. Both hb-redundancy number and lb-redundancy number
default to 0.
standard-t38: Adopts the standard T.38 (UDP) fax protocol, which supports
■
H.323-T.38 and SIP-T.38 protocols.
pcm: Enables the passthrough mode.
■
g711alaw: Adopts G.711 A-law.
■
g711ulaw: Adopts G.711 μ-law.
■
t38: Enables T.38 fax protocol.
■
hb-redundancy number: Number of redundant high-speed T.38 packets, in
■
the range of 0 to 2.
lb-redundancy number: Number of redundant low-speed T.38 packets, in the
■
range of 0 to 5.
train-mode: Specifies the fax training mode. By default, the point-to-point
training mode is adopted.
local: Adopts local training.
■
ppp: Adopts point-to-point training.
■
Use the
default entity fax
globally.
Use the
undo default entity fax
system to the defaults.
n
You must carry out the default entity fax train-mode local command before
the configuration made by the default entity fax local-train threshold
command takes effect.
# Set the maximum fax rate to 9,600 bps globally.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] default entity fax baudrate 9600
display voice fax statistics
Any view
command to set fax parameters to the default values
command to restore the fax parameters of the