H3C MSR 20-20 Command Reference Manual page 2487

Port Operating Status
Port IEEE Class
Port Detection Status
Port Power Mode
Port Current Power
Port Average Power
Port Peak
Port Max Power
Port Current
Port Voltage
Port PD Description
Table 640 Description on fields of the display poe interface ethernet command
Field
Port Power Enabled
Port Power Priority
Port Operating Status
Port IEEE class
Port Detection Status
: on
: 1
: delivering-power
: signal
: 11592
: 11610
: 11684
: 15400
: 244
: 51.7
: IP Phone For Room 101
Description
PoE enabled/disabled state
enable: PoE is enabled.
■
disable: PoE is disabled.
■
Power priority of the PoE interface:
critical (highest)
■
high
■
low
■
Operating state of a PoE interface:
off: PoE is disabled.
■
on: Power is supplied for a PoE interface normally.
■
power lack: The guaranteed remaining power of the PSE is
■
not high enough to supply power for a critical PoE interface.
power-deny: The PSE refuses to supply power. The power
■
required by the powered device (PD) is higher than the
configured power.
power-itself: The external equipment is supplying power for
■
itself.
power-limit: The PSE is supplying a limited power. The power
■
required by the PD is higher than the configured power and
the PSE still supplies the configured power.
Different models of device support different operating states.
■
PD power class: 0, 1, 2, 3, 4, and -
The support for the - field depends on the device model.
Power detection state of a PoE interface:
disabled: The PoE function is disabled.
■
searching: The PoE interface is searching for the PD.
■
delivering-power: The PoE interface is supplying power for the
■
PD.
fault: There is a fault defined in 802.3af.
■
test: The PoE interface is under test.
■
other-fault: There is a fault other than defined in 802.3af.
■
pd-disconnect: The PD is disconnected.
■
Different models of device support different detection states.
mW
mW
mW
mW
mA
V
2487