Redirect Disconnect; Redirect Enable - H3C MSR 20-20 Command Reference Manual

redirect disconnect

Syntax
View
Parameter
Description
Example

redirect enable

Syntax
View
Parameter
Description
<Sysname> system-view
[Sysname] user-interface vty 0 4
[Sysname-ui-vty0-4] authentication-mode scheme
[Sysname-ui-vty0-4] protocol inbound ssh
redirect disconnect
User interface view
None
Use the
redirect disconnect
connection.
n
The redirect commands are supported on the AUX and TTY user interfaces
■
only.
Execute the command after using the redirect enable command to enable
■
redirection on the user interface.
# Manually terminate a redirected Telnet connection.
<Sysname> system-view
[Sysname] user-interface tty 1
[Sysname-ui-tty1] redirect disconnect
redirect enable
undo redirect enable
User interface view
None
Use the
redirect enable
asynchronous serial interface.
Use the
undo redirect enable
By default, the redirection function is disabled.
n
The redirect commands are supported on the AUX and TTY user interfaces
■
only.
To use the redirection function or configure redirection-related parameters, use
■
this command to enable redirection on the user interface.
command to manually terminate a redirected telnet
command to enable redirection on the active
command to disable this function.
2465