Ani-Offset; Answer Enable - H3C MSR 20-20 Command Reference Manual

2648 C 175: E1
HAPTER AND

ani-offset

Syntax
View
Parameter
Description
Related command:
Example

answer enable

Syntax
View
Parameter
Description
T1 C C
ONFIGURATION OMMANDS
ani-offset number
undo ani-offset
R2 CAS view
number: Number of digits to be collected, in the range of 1 to10.
Use the
ani-offset
that need to be collected prior to requesting calling party information.
Use the
undo ani-offset
Before adequate digits are collected, the system will wait for the next digit until
the timer expires. During this period, the system does not request calling party
information. It does that only after adequate digits are collected.
By default, the number of digits to be collected before the calling party
information is 1.
This command applies to R2 signaling only.
cas, timer, reverse, and renew.
# Start requesting calling number or caller identifier after receiving three digits.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] ani all
[Sysname-cas1/0:0] ani-offset 3
answer enable
undo answer enable
R2 CAS view
None
Use the
answer enable
the terminating point to send answer signal. Only after receiving an answer signal
can the two parties begin to talk.
Use the undo answer enable
command to configure the number of called number digits
command to restore the default value.
command to configure the originating point to require
command to restore the default.