Address - H3C MSR 20-20 Command Reference Manual

179

address

Syntax
View
Parameter
Description
Related command:
Example
V FR C
O ONFIGURATION
address { vofr-dynamic serial interface-number dlci-number | vofr-static serial
interface-number dlci-number cid-number }
undo address { vofr-dynamic | vofr-static }
VoFR entity view
vofr-dynamic: Specifies a VoFR entity to adopt the dynamic call mode.
vofr-static: Specifies a VoFR entity to adopt the FRF.11 trunk mode.
serial interface-number: Specifies the destination interface of a VoFR entity.
dlci-number: Destination virtual circuit number of a VoFR entity, in the range of 16
to 1007.
cid-number: Destination FRF.11 sub-channel number of a VoFR entity, in the range
of 4 to 255.
Use the command to configure a channel to the peer voice gateway.
address
Use the undo address
By default, no channel to the peer voice gateway is configured.
Note that:
The FRF.11 sub-channel number to be configured must be available. That is, the
■
FRF.11 sub-channel is not occupied.
A voice channel will be established for the VoFR entity immediately you execute
■
the address vofr-static command. The voice channel will be removed after
you execute the undo form of the command or delete the VoFR entity.
call-mode, vofr, trunk-id, and display fr vofr-info.
# Specify DLCI 100 to adopt the dynamic call mode.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
command to remove the configuration.
C
OMMANDS