Renew - H3C MSR 20-20 Command Reference Manual

2664 C 175: E1
HAPTER AND
Related command:
Example

renew

Syntax
View
Parameter
Description
T1 C C
ONFIGURATION OMMANDS
You may set a signal value to 16 to indicate that the signal function does not exist.
For example, if the send last digit signal is not available in a national R2 signaling
variant, you may set the value for req-lastfirstdigit to 16.
The purpose of the register-value command is to assign values for signals
requesting responses from the remote end. For example, after you configure the
register-value callingcategory command, the terminating point sends the send
calling category signal with the specified value to the originating point for the
calling category.
This command applies to R2 signaling only.
n
As some national register signal coding schemes may not support all the register
signals mentioned in this section, you are recommended to use defaults unless
necessary. For example, the ITU-T recommendation is available with the send
calling category signal (the callingcategory keyword) but not the send billing
category (billingcategory) signal.
group-b enable.
# Request the originating point to send calling category by configuring a
backward signal (signal value 7).
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] register-value req-callingcategory 7
renew ABCD
undo renew
R2 CAS view
ABCD: Defines the default of each signal bit in transmission. Each bit can take the
value of 0 or 1. The default C and D bit values vary by country mode.
Use the
renew
signaling.
Use the
undo renew
with R2 signaling standards in countries.
This command applies to R2 signaling only.
R2 signaling uses bits A and B to convey real status information while leaving bits
C and D constant. The values of bits C and D are national variant dependent. For
example, they are fixed to 01 in most countries but 11 in some other countries.
command to configure the values of C bit and D bit in R2
command to restore the default. The default value varies