Vi-Card Busy-Tone-Detect - H3C MSR 20-20 Command Reference Manual

vi-card busy-tone-detect

Syntax
View
Parameter
Description
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 pots
[Sysname-voice-dial-entity10] vad-on
vi-card busy-tone-detect { auto index line-number | custom area-number index argu
f1 f2 p1 p2 p3 p4 p5 p6 p7 }
undo vi-card busy-tone-detect custom index
Voice view
index: Index of busy tone type, in the range of 0 to 3.
line-number: Voice subscriber line number. The value range varies with the
inserted cards.
area-number: Area number. Currently, it is set to 2.
argu: Reserved, in the range of 0 to 32,767.
f1: Frequency 1 in Hz, in the range of 50 to 3,600.
f2: Frequency 2 in Hz, in the range of 50 to 3,600.
p1: Signal amplitude 1, in the range of 50 to 32,767.
p2: Signal amplitude 2, in the range of 50 to 32,767.
p3: Duration of a single tone in milliseconds, in the range of 10 to 1,000.
p4: Duration error of a single tone in milliseconds, in the range of 0 to 500.
p5: Duration of silence in milliseconds, in the range of 10 to 1,000.
p6: Duration error of silence in milliseconds, in the range of 0 to 500.
p7: Absolute difference between p3 and p5 in milliseconds, in the range of 0 to
500
Use the
vi-card busy-tone-detect
the busy tone detection on the FXO interface.
Use the
undo vi-card busy-tone-detect
settings.
This command applies to the FXO interface only.
The system supports four types of busy tones, which are specified by the index
argument.
command to configure the parameters for
command to restore the default
2617