Voice-Setup; Voip Called-Tunnel Enable - H3C MSR 20-20 Command Reference Manual

2620 C 173: V IP C
HAPTER O
Related command:
Example

voice-setup

Syntax
View
Parameter
Description
Example

voip called-tunnel enable

Syntax
View
Parameter
Description
Related command:
C
ONFIGURATION OMMANDS
display version on page 2417, and display device on page 2251.
c
CAUTION: You can use this command to reset only the analog voice cards of SIC
and MIM. To reset digital voice card and FIC analog voice card, carry out the
reboot slot slot-number command in system view.
# Reset the voice card of slot 3.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] vi-card reboot 3
voice-setup
System view
None
Use the
voice-setup
# Enter voice view and enable voice services.
<Sysname> system-view
[Sysname] voice-setup
voip called-tunnel enable
undo voip called-tunnel enable
Voice view
None
Use the
voip calledtunnel enable
the called gateway.
Use the undo voip calledtunnel enable
function on the called gateway.
By default, the tunnel function on the called gateway is enabled.
tunnel-on.
n
If the voip called-start normal command is configured, the voip called-tunnel
enable command is unavailable.
command to enter voice view and enable voice services.
command to enable the tunnel function on
command to disable the tunnel