Send-Busytone - H3C MSR 20-20 Command Reference Manual

Parameter
Description
Example

send-busytone

Syntax
View
Parameter
Description
Example
value: Value of the payload type field in RTP packets, in the range of 96 to 127.
Use the
rtp payload-type nte
RTP packets in the case of DTMF relay using NTE.
Use the
undo rtp payload-type nte
By default, the payload type field in RTP packets is set to 101 in the case of DTMF
relay using NTE.
n
It is forbidden to set the NTE payload type field to "98", which has already
■
been used to identify nonstandard T38 fax packets.
When the device is connected with devices of other manufacturers for
■
communication, you cannot set the payload type field to any forbidden by
these routers. Otherwise, an NTE negotiation failure may occur.
# Set the NTE payload type field to "102" for VoIP entity 10.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 voip
[Sysname-voice-dial-entity10] rtp payload-type nte 102
send-busytone { enable | time seconds }
undo send-busytone { enable | time }
Analog FXO voice subscriber line view
enable: Enables busy-tone sending on the FXO interface.
time seconds: Duration of busy tone in seconds, in the range of 2 to 15. It
defaults to 3 seconds. This parameter is not available without using the
send-busytone enable command to enable busy-tone sending function.
Use the
send-busytone
interface. Use the undo send-busytone command to disable busy tone sending
on the FXO interface.
By default, busy tone sending is disabled.
# Enable FXO interface 1/0 to send busy tone that lasts 5 seconds.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1/0] send-busytone enable
[Sysname-voice-line1/0] send-busytone time 5
command to configure the payload type field in
command to restore the default.
command to enable busy tone sending on the FXO
2607