H3C MSR 20-20 Command Reference Manual page 2739

Description
Related command:
Example
is implemented by identifying the calling number. If the authentication succeeds,
the voice gateway plays prompt tones, requiring the user to dial a called number.
In addition, you can configure the number of redial attempts by using the
redialtimes command, and the language in which the prompt tones are played
by using the selectlanguage command.
Use the
process-config
number.
Use the undo process-config
for an access number.
By default, the caller number process with IVR is specified for all access numbers.
Each access number has a specific dialing process. Calls originated by users who
dial a certain access number are established in accordance with the same dialing
process.
Differences between the caller number process and the caller number process with
IVR are as follows:
In the caller number process, after a user dials an access number, the voice
■
gateway plays only dial tones (long tones).
In the caller number process with IVR, after a user dials an access number, the
■
voice gateway will play prompt tones, requiring the user to dial a called
number.
In the card number/password process, with the authentication function disabled, a
user can enter any two numbers as a card number and password respectively to
make an IP call as long as they meet the length requirements.
After a dialing process is specified, parameters not related to the process are set to
the default values and the corresponding commands are unavailable. Parameters
related to the card number/password process include number of digits in a card
number and number of digits in a password. The language selection function is
applicable only to the caller number process with IVR, while the number of redial
attempts is applicable to only the card number/password process and the caller
number process with IVR.
gw-access-number, card-digit, password-digit and selectlanguage.
# Specify the dialing process for the access number 17909 as card
number/password process.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] gw-access-number 17909
[Sysname-voice-dial-anum17909] process-config cardnumber
# Restore the default dialing process for the access number 17909.
[Sysname-voice-dial-anum17909] undo process-config
command to specify a dialing process for an access
command to restore the default dialing process
2739