Dscp Media; Dtmf Amplitude - H3C MSR 20-20 Command Reference Manual

dscp media

Syntax
View
Parameter
Description
Example

dtmf amplitude

Syntax
View
Parameter
Description
Example
dscp media dscp-value
undo dscp media
POTS/VoIP entity view
dscp-value: DSCP value in the range of 0 to 63 or the keyword af11, af12, af13,
af21, af22, af23, af31, af32, af33, af41, af42, af43, cs1, cs2, cs3, cs4, cs5, cs6,
cs7, and ef.
Use the command to set the DSCP value in the ToS field in the IP
dscp media
packets that carry the RTP stream of the voice entity.
Use the
undo dscp media
By default, the DSCP value is ef (101110).
# Set the DSCP value in the ToS field of the IP packets that carry the RTP stream of
VoIP voice entity to af41.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 2 voip
[Sysname-voice-dial-entity2] dscp media af41
dtmf amplitude value
undo dtmf amplitude
Voice view
value: DTMF amplitude in 0.1 dBm increments, in the range of -9.0 to -7.0.
Use the
dtmf amplitude
configured, the parameter applies to the whole device.
Use the undodtmf amplitude
By default, the DTMF amplitude is -9.0 dBm.
Note that the configuration will apply to the whole device once you carry out this
command.
# Configure the DTMF amplitude to -8.0 dBm
command to restore the default DSCP.
command to configure the DTMF amplitude. Once
command to restore the default value.
2587