H3C MSR 20-20 Command Reference Manual page 2488

2488 C 166: P E C
HAPTER O
C
ONFIGURATION OMMANDS
Table 640 Description on fields of the display poe interface ethernet command
Field
Port Power Mode
Port Current Power
Port Average Power
Port Peak Power
Port Max Power
Port Current
Port Voltage
Port PD Description
# Display the state of all PoE interfaces.
<Sysname> display poe interface
Interface Enable
GE0/1 enable
GE0/2 enable
GE0/3 enable
GE0/4 enable
GE0/5 enable
GE0/6 enable
GE0/7 disable
GE0/8 disable
GE0/9 disable
GE0/10 disable
GE0/11 disable
GE0/12 disable
--- 2 port(s) on,
Table 641 Description on fields of the display poe interface command
Field
Interface
Enable
Priority
CurPower
Description
Power mode of a PoE interface:
signal: Power is supplied over signal cables.
■
spare: Power is supplied over spare cables.
■
Different models of device support different power supply
modes.
Current power of a PoE interface, including PD consumption
power and transmission loss
The transmission loss usually does not exceed one watt. The
specific loss depends on the device model.
Average power of a PoE interface
Peak power of a PoE interface
Maximum power of a PoE interface
Current of a PoE interface
Voltage of a PoE interface
Description of the PD connected to the PoE interface, which is
used to identify the type and location of the PD.
Priority CurPower
(W)
low 4.4
critical 0
low 0
critical 0
low 4.0
low 0
low 0
low 0
low 0
low 0
low 0
low 0
8.4(W) consumed,
Description
Shortened form of a PoE interface
PoE enabled/disabled state:
enable: PoE is enabled.
■
disable: PoE is disabled.
■
Power priority of a PoE interface:
critical (highest)
■
high
■
low
■
Current power of a PoE interface
Operating IEEE Detection
Status class
on 1
on -
on -
on -
on 2
on -
off -
off -
off -
off -
off -
off -
171.6(W) Remaining ---
Status
delivering-power
disabled
disabled
searching
delivering-power
disabled
fault
disabled
disabled
disabled
disabled
disabled