Sendring Ringbusy Enable - H3C MSR 20-20 Command Reference Manual

Description
Related command:
Example

sendring ringbusy enable

Syntax
View
Parameter
Description
Related command:
Example
min: Selects the timeslot with the smallest number from currently available
timeslots.
minpoll: Selects the timeslot with the lowest number from available timeslots in
the first timeslot polling; in later pollings, selects in ascending order timeslots with
numbers greater than the one picked out in the previous polling. Suppose TS1 and
TS3 are not available. In the first polling, TS2 will be picked out for use and in the
next polling, TS4.
Use the select-mode
Use the
undo select-mode
By default, the timeslot with the smallest number is selected.
cas and trunk-direction.
# Set the trunk routing mode for TS group 5 to max on interface E1 1/0.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 5 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 5
[Sysname-cas1/0:5] select-mode max
sendring ringbusy enable
undo sendring ringbusy enable
R2 CAS view
None
Use the
sendring ringbusy enable
to send busy tones to calling subscribers.
Use the
undo sendring ringbusy enable
point from sending busy tones to calling subscribers.
By default, the terminating point sends busy tones to calling subscribers.
This command applies to R2 signaling only.
timer ring.
# On TS group 5 on interface E1 1/0 configure the terminating point to send
ringback tone to the calling side.
command to set the E1 trunk routing mode.
command to restore the default.
command to enable the terminating point
command to disable the terminating
2667