H3C MSR 20-20 Command Reference Manual page 2441

Msr 20/30/50 series routers

Hide thumbs Also See for MSR 20-20:

Table of Contents

By default, the output rules for the system information are listed in Table 633.

This command can be used to filter and redirect system information.

For example, the user can set to output log information with severity higher than

warnings to the log host, and information with severity higher than informational

to the log buffer. The user can also set to output trap information of the IP module

to a specified output direction.

If you do not use the module-name argument to set output rules for a module,

the module uses the default output rules or the output rules set by the default

keyword; otherwise the module uses the output rules separately set for it.

When you use the module-name argument to separately set the output rules

for a module, the default output rules for the module become: Log and trap

information is enabled, with severity being informational; debug information is

disabled, with severity being debugging.

After you separately set the output rules for a module, you must use the

module-name argument to modify or remove the rules. The new configuration

by using the default keyword is invalid on the module.

Table 633 Default output rules for different output directions

Log buffer default (all

# Set the output channel for the log information of VLAN module to snmpagent

and to output information with severity being emergencies.

<Sysname> system-view

[Sysname] info-center source vlan channel snmpagent log level emergencies

-center source command to remove the specified output

default (all

default (all

default (all

default (all

default (all

default (all

Chapters

Table of Contents

Msr 20-21Msr 30-16Msr 30-20Msr 30-40Msr 30-60Msr 50 ... Show all