Delay Start-Dial; Description (Voice Entity View) - H3C MSR 20-20 Command Reference Manual

2574 C 173: V IP C
HAPTER O
Related command:
Example

delay start-dial

Syntax
View
Parameter
Description
Example

description (voice entity view)

Syntax
View
Parameter
Description
C
ONFIGURATION OMMANDS
Use the undo delay wink-rising
By default, the maximum amount of time the originating side waits for a wink
signal after sending a seizure signal is 3,000 milliseconds in the wink start mode.
em-signal.
# Set the maximum amount of time the originating side waits for a wink signal
after sending a seizure signal in the wink start mode to 2,000 milliseconds.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1/0] em-signal wink
[Sysname-voice-line1/0] delay wink-rising 2000
delay start-dial seconds
undo delay start-dial
FXS/FXO voice subscriber line view
seconds: Dial delay in seconds, in the range of 0 to 10.
Use the
delay start-dial
Use the undo delay start-dial
By default, the dial delay is 1 second.
# Set the dial delay on FXS subscriber line 1/0 to 5 seconds.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1/0] delay start-dial 5
description text
undo description
POTS/VoIP/VoFR entity view
text: Voice entity description string, consisting of up to 80 characters.
Use the description
command to restore the default.
command to configure the dial delay.
command to restore the default.
command to configure a voice entity description string.