Ipx Rip Multiplier; Ipx Rip Mtu - H3C MSR 20-20 Command Reference Manual

Example

ipx rip mtu

Syntax
View
Parameter
Description
Example

ipx rip multiplier

Syntax
View
Parameter
Description
Note that RIP only redistributes active static routes, rather than inactive routes.
# Enable static route redistribution to RIP.
<Sysname> system-view
[Sysname] ipx rip import-route static
ipx rip mtu bytes
undo ipx rip mtu
Interface view
bytes: Maximum RIP updating packet size in bytes, ranging from 432 to 1,500.
Use the command to configure the maximum RIP updating packet
ipx rip mtu
size.
Use the
undo ipx rip mtu
The default is 432 bytes.
In RIP updating packets, the size of each routing information item is 8 bytes and
the size of IPX header plus RIP header is 32 bytes. So an updating packet can carry
up to 50 routing information items at most.
# Specify the maximum RIP updating packet size as 500 bytes on the interface
Ethernet 1/0.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] ipx rip mtu 500
ipx rip multiplier multiplier
undo ipx rip multiplier
System view
multiplier: Used to calculate the aging period of RIP routing items, ranging from 1
to 1000. The actual aging time is the value of multiplier multiplied by the RIP
updating interval.
Use the
ipx rip multiplier
routing items.
command to restore the default.
command to configure the aging interval of IPX RIP
2541