Entity - H3C MSR 20-20 Command Reference Manual

2594 C 173: V IP C
HAPTER O
View
Parameter
Description
Related command:
Example

entity

Syntax
View
Parameter
Description
C
ONFIGURATION OMMANDS
E&M voice subscriber line view
delay: When using the delay start mode, the calling end occupies the trunk line,
and the called end, such as PBX, will also enter the hook-off state to respond the
caller till it is ready for receiving the called number.
immediate: Immediate start mode. The caller end hooks off to seize the line
through line E and sends the called number. The prerequisite for using the
immediate start mode is: The equipment at the remote end should listen to the
dial signal immediately after identifying the off-hook signal.
wink: Wink start mode. The caller end hooks off to seize the line through line E,
and it has to wait for a wink signal from the remote end before sending out the
called number.
Use the
em-signal
subscriber line.
Use the undo em-signal
By default, the immediate start mode is selected for the analog E&M subscriber
line.
delay.
# Configure delay mode.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1/0] em-signal delay
entity entity-number { pots | voip }
undo entity { entity-number | all | pots | voip }
Voice dial program view
entity-number: Identifies a voice entity. The value ranges from 1 to 2147483647.
all: All voice entities.
pots: Indicates that the voice entity originates a call from the local voice subscriber
line.
voip: Indicates that the voice entity originates a call from the network side.
Use the command to enter voice entity view, or configure a voice entity
entity
and then enter its view if the voice entity does not exist.
command to configure a start mode for an analog E&M voice
command to restore the default start mode.