Example
stopbits
Syntax
View
Parameter
Description
Example
terminal type
Syntax
View
Parameter
Description
n
The command is only applicable to asynchronous serial interfaces including AUX
and Console ports.
# Set the transmission rate on the user interface AUX 0 to 19200 bps.
<Sysname> system-view
[Sysname] user-interface aux 0
[Sysname-ui-aux0] speed 19200
stopbits { 1 | 1.5 | 2 }
undo stopbits
User interface view
1: 1 stop bit.
1.5: 1.5 stop bits.
2: 2 stop bits.
Use the
stopbits
Use the
undo stopbits
n
The command is only applicable to asynchronous serial interfaces including AUX
and Console ports.
# Set the stop bits on the user interface to 1.5.
<Sysname> system-view
[Sysname] user-interface aux 0
[Sysname-ui-aux0] stopbits 1.5
terminal type { ansi | vt100 }
undo terminal type
User interface view
ansi: Specifies the terminal display type as ANSI.
vt100: Specifies the terminal display type as VT100.
Use the
terminal type
command to set the stop bits on the user interface.
command to restore the default, or one stop bit.
command to configure the type of terminal display.
2473