Cid Send; Cid Type - H3C MSR 20-20 Command Reference Manual

Example

cid send

Syntax
View
Parameter
Description
Example

cid type

Syntax
If a number is configured in the number template for the POTS entity
■
associated with the local FXO interface, the interface substitutes this number
for the calling number and sends it to the called side.
If wildcard dots (.) are used in the number configured in the number template
■
for the POTS entity associated with the local FXO interface, the interface
substitutes zeros for the calling number's digits in the place of dots, for
example, 1000 for 1... and then sends the substitution number to the called
side.
# Enable CID on voice subscriber line 1/0.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1/0] cid receive
cid send
undo cid send
FXS/FXO voice subscriber line view
None
Use the cid send command to enable the FXS or FXO voice subscriber line to send
calling numbers to the remote end.
Use the
undo cid send
from send calling numbers to the remote end.
By default, the FXS or FXO voice subscriber line sends calling numbers to the
remote end.
After you configure the undo cid send command, the FXS or FXO voice
subscriber line will not send any calling number to the called side, whether the
originating side has sent it or it is configured in the number template for the voice
entity associated with the FXS or FXO voice subscriber line.
# Disable voice subscriber line 1/0 from sending calling numbers to the IP network.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1/0] undo cid send
cid type { complex | simple }
command to disable the FXS or FXO voice subscriber line
2557