Table of Contents
Advertisement
UM-WI-056
DA16200 DA16600 FreeRTOS Getting Started Guide
Table 5: Serial Port Configuration Values
Settings
Baud Rate
Data Bits
Parity
Stop Bits
Flow Control (HW/SW)
Turn ON the EVB (SW6 on the DA16200 EVB or SW2 on the DA16600 EVB) and check f or output
similar to the f ollowing:
Wakeup source is 0x4
[dpm_init_retmemory] DPM INIT CONFIGURATION(1)
******************************************************
*
* ---------------------------------------------------
*
* - CPU Type
* - OS Type
* - Serial Flash
* - SDK Version
* - F/W Version
* - F/W Build Time : Aug 26 2021 22:58:01
* - Boot Index
*
******************************************************
System Mode : Station Only (0)
>>> DA16x Supp Ver2.7 - 2020_07
>>> MAC address (sta0) : d4:3d:39:10:a2:48
>>> sta0 interface add OK
>>> Start STA mode...
[/DA16200] #
Commands can be entered at the[/DA16200] prompt. A f ull list of the available debug interf ace
commands can be f ound in
4.4.2
Configuring DA14531 Serial Debug Interface
This section is f or DA16600 only and is required f or special cases where access to the DA14531 BLE
devices debug terminal is required.
The DA16600 EVB contains the DA14531 BLE device which is used f or provisioning of the DA16600
Wi-Fi interf ace using a mobile application. On the DA16600 EVB, the DA14531 debug interf ace can
be connected to the higher numbered COM port that is created when the USB cable is connected to
CN1.
To enable the DA14531 debug interf ace, f ollow the settings below f or SW4, SW5, SW6 and SW7.
Table 6: Debug Switch Settings
Switch
Pin
Relevant pin
SW4
1
DA14531
2
User Manual
CFR0012
Value
230400
8
None
1
None
DA16200 SDK Information
: Cortex-M4 (120MHz)
: FreeRTOS 10.4.3
: 4 MB
: V3.1.3.0 GEN
: FRTOS-GEN01-01-15129-000000
: 0
Appendix B.
P0_8
Connects FT2232H to P0_8 (UART_RXD)
P0_9
Connects FT2232H to P0_9 (UART_TXD)
Revision 1.8
16 of 106
ON
Aug. 18, 2023
© 2023 Renesas Electronics
Default
ON
Advertisement
Table of Contents
