Module Stop Control Register (Mstpcr) - Renesas H8S Series Hardware Manual

10.2.10 Module Stop Control Register (MSTPCR)

Bit : 15 14
Initial value : 0 0
R/W : R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W
MSTPCR is a 16-bit readable/writable register that performs module stop mode control.
When the MSTP13 bit in MSTPCR is set to 1, TPU operation stops at the end of the bus cycle and a transition is made to
module stop mode. Registers cannot be read or written to in module stop mode. For details, see section 21.5, Module Stop
Mode.
MSTPCR is initialized to H'3FFF by a reset and in hardware standby mode. It is not initialized in software standby mode.
Bit 13—Module Stop (MSTP13): Specifies the TPU module stop mode.
Bit 13
MSTP13
0
1
Rev.6.00 Oct.28.2004 page 368 of 1016
REJ09B0138-0600H
MSTPCRH
13 12 11 10
1 1 1 1
Description
TPU module stop mode cleared
TPU module stop mode set
MSTPCRL
9 8 7 6 5
1 1 1 1 1
4 3 2 1 0
1 1 1 1 1
(Initial value)