Renesas H8S Series Hardware Manual page 520

Figure 14-4 shows a sample SCI initialization flowchart.
Clear TE and RE bits in SCR to 0
Set CKE1 and CKE0 bits in SCR
Set data transfer format in
SCR to 1, and set RIE, TIE, TEIE,
Rev.6.00 Oct.28.2004 page 492 of 1016
REJ09B0138-0600H
Start initialization
(TE, RE bits 0)
SMR and SCMR
Set value in BRR
Wait
1-bit interval elapsed?
Yes
Set TE and RE bits in
and MPIE bits
<Transfer completion>
Figure 14-4 Sample SCI Initialization Flowchart
[1] Set the clock selection in SCR.
Be sure to clear bits RIE, TIE,
TEIE, and MPIE, and bits TE and
RE, to 0.
When the clock is selected in
asynchronous mode, it is output
[1]
immediately after SCR settings are
made.
[2] Set the data transfer format in SMR
and SCMR.
[2]
[3] Write a value corresponding to the
bit rate to BRR. Not necessary if an
[3]
external clock is used.
[4] Wait at least one bit interval, then
set the TE bit or RE bit in SCR to 1.
No
Also set the RIE, TIE, TEIE, and
MPIE bits.
Setting the TE and RE bits enables
the TxD and RxD pins to be used.
[4]