Flash Memory Programmer Mode; 19.13.1 Programmer Mode Setting; 19.13.2 Socket Adapters And Memory Map - Renesas H8S Series Hardware Manual

19.13

Flash Memory Programmer Mode

19.13.1 Programmer Mode Setting

Programs and data can be written and erased in programmer mode as well as in the on-board programming modes. In
programmer mode, the on-chip ROM can be freely programmed using a PROM programmer that supports Renesas
Technology microcomputer device types with 128-kbyte on-chip flash memory. Flash memory read mode, auto-program
mode, auto-erase mode, and status read mode are supported with this device type. In auto-program mode, auto-erase
mode, and status read mode, a status polling procedure is used, and in status read mode, detailed internal signals are output
after execution of an auto-program or auto-erase operation.
Table 19-18 shows programmer mode pin settings.
Table 19-18 Programmer Mode Pin Settings
Pin Names
Mode pins: MD
Mode setting pins: P66, P65, P64
FWE pin
STBY pin
RES pin
XTAL, EXTAL pins
Other pins requiring setting: P51, P25

19.13.2 Socket Adapters and Memory Map

In programmer mode, a socket adapter is mounted on the PROM programmer to match the package concerned. Socket
adapters are available for each writer manufacturer supporting the Renesas Technology microcomputer device type with
128-kbyte on-chip flash memory.
Figure 19-24 shows the memory map in programmer mode. For pin names in programmer mode, see section 1.3.2, Pin
Functions in Each Operating Mode.
Rev.6.00 Oct.28.2004 page 604 of 1016
REJ09B0138-0600H
, MD , MD
2 1 0
MCU mode
H'000000
H'01FFFF
Figure 19-24 Memory Map in Programmer Mode
Settings/External Circuit Connection
Low-level input
High-level input to P66, low-level input to P65 and P64
High-level input (in auto-program and auto-erase
modes)
High-level input (do not select hardware standby mode)
Power-on reset circuit
Oscillator circuit
High-level input to P51 and P25
H8S/2357
Programmer mode
F-ZTAT
H'00000
On-chip
ROM area
H'1FFFF