Access State Control Register (Astcr) - Renesas H8S Series Hardware Manual

6.2.2

Access State Control Register (ASTCR)

Bit : 7
AST7
Initial value : 1
R/W : R/W
ASTCR is an 8-bit readable/writable register that designates each area as either a 2-state access space or a 3-state access
space.
ASTCR sets the number of access states for the external memory space. The number of access states for on-chip memory
and internal I/O registers is fixed regardless of the settings in ASTCR.
ASTCR is initialized to H'FF by a power-on reset and in hardware standby mode. It is not initialized by a manual reset* or
in software standby mode.
Note: * Manual reset is only supported in the H8S/2357 ZTAT.
Bits 7 to 0—Area 7 to 0 Access State Control (AST7 to AST0): These bits select whether the corresponding area is to
be designated as a 2-state access space or a 3-state access space.
Wait state insertion is enabled or disabled at the same time.
Bit n
ASTn
0
1
6 5
AST6 AST5
1 1
R/W R/W
Description
Area n is designated for 2-state access
Wait state insertion in area n external space is disabled
Area n is designated for 3-state access
Wait state insertion in area n external space is enabled
4 3 2
AST4 AST3 AST2
1 1 1
R/W R/W R/W
1 0
AST1 AST0
1 1
R/W R/W
(Initial value)
Rev.6.00 Oct.28.2004 page 109 of 1016
REJ09B0138-0600H
(n = 7 to 0)