Disable-Switch-On-Error - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
disable-switch-on-error
Syntax
Release Information
Description
Mode
520
[ no ] disable-switch-on-error
Command introduced before JunosE Release 7.1.0.
Prevents the redundant SRP module from taking over if the primary SRP module
experiences a software failure or if you push the reset button on the primary SRP module.
Issue the sync command immediately before you issue this command. The no version
restores the default situation, in which the redundant SRP module takes over if the primary
SRP module experiences a failure.
Global Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers