Table of Contents
Advertisement
schedule-power-control port-led
Configures LED operation during scheduled power saving.
Input format
To set or change information:
schedule-power-control port-led { enable | economy | disable }
To delete information:
no schedule-power-control port-led
Input mode
(config)
Parameters
enable
Turns on the Switch LED according to the operating status.
When the
When the
economy
Regardless of operation status, the Switch turns on and blinks with power saving
brightness.
disable
Regardless of the operating status, the Switch LED turns off.
At this time, the ST1 LED blinks green at long intervals to indicate that the LED is
about to turn off.
1.
2.
Default behavior
Regardless of operation status, the Switch turns on and blinks with normal brightness.
system port-led trigger
Regardless of the operating status, the LED turns on and blinks with normal
brightness.
system port-led trigger
Operates under the following conditions:
1.
The LED switches to normal brightness when automatic operation is
triggered, and then it turns on and blinks.
2.
60 seconds after automatic operation finishes, the LED switches to
power saving brightness, and then turns on and blinks.
3.
10 minutes after power saving brightness started, the LED turns off. If
any automatic operation is performed during this period, the LED
switches to normal brightness, and then turns on and blinks.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
,
, and
enable
economy
command is not set:
command is set:
disable
schedule-power-control port-led
57
Advertisement
Table of Contents
