Table of Contents
Advertisement
spanning-tree single port-priority
Sets the priority for the applicable single-spanning-tree ports.
Input format
To set or change information:
spanning-tree single port-priority
To delete information:
no spanning-tree single port-priority
Input mode
(config-if)
Parameters
<Priority>
Sets the port priority. Use a multiple of 16 as the port priority. The lower the priority
value, the higher the priority.
1.
2.
3.
Default behavior
The setting of the
spanning-tree port-priority
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
None
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
0 to 240
Notes on using this parameter:
Changing the port priority might change the topology.
spanning-tree port-priority
command has not been set, 128 is set as the port priority.
spanning-tree single port-priority
<Priority>
command is used. If the
191
Advertisement
Table of Contents
