Table of Contents
Advertisement
ip access-group
ip access-group
Sets the access list that specifies the IPv4 addresses of the remote operation terminals for
which remote login to the Switch is to be permitted or denied is set. This setting is common
to all types of remote access (Telnet or FTP).
Multiple lines for no more than 16 entries, including those in the access list set by using
access-group
Input format
To set or change information:
ip access-group
To delete information:
no ip access-group
Input mode
(config-line)
Parameters
<ACL ID>
1.
2.
Default behavior
Sets
line vty
terminals is permitted.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
This setting is common to all types of remote access (Telnet or FTP).
2.
To allow FTP connections, set
3.
Sets
operation terminals is permitted.
24
, can be set.
<ACL ID>
<ACL ID>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Standard
ip access-list
. If
ip access-group
line vty
. If
ip access-group
in
name (
ip access-list standard
has not been set, access from all remote operation
in config mode.
ftp-server
has not been set, access from all remote
ip
)
Advertisement
Table of Contents
