Table of Contents
Advertisement
Notes
1.
If the applicable interface is set as a trunk port, set
switchport trunk
is not set, all frames on the applicable interface are discarded.
2.
If the applicable interface is set as a protocol port, set the protocol VLAN by using the
switchport protocol
interface operates as an access port.
3.
If the applicable interface is set as an MAC port, set the MAC VLAN by using the
switchport mac
operates as an access port.
4.
You cannot make changes using this command if the following commands are set for
the applicable interface:
dot1x port-control
mac-authentication port
web-authentication port
Related commands
None
command. If an interface is set as a trunk port and
command. If the protocol VLAN is not set, the applicable
command. If the MAC VLAN is not set, the applicable interface
switchport mode
by using the
allowed vlan
allowed vlan
135
Advertisement
Table of Contents
