Table of Contents
Advertisement
mac-authentication authentication
Sets the name of an authentication method list for the port-based authentication method.
Input format
To set or change information:
mac-authentication authentication
To delete information:
no mac-authentication authentication
Input mode
(config-if)
Parameters
<List name>
Sets the authentication method list name set by using the
mac-authentication
1.
2.
Default behavior
MAC-based authentication is performed by using the default values of the Switch.
Impact on communication
Authentication of a terminal for a port whose authentication method list name has been
changed is canceled.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
All MAC-based authentication settings take effect when the
system-auth-control
2.
See Configuration commands and MAC-based authentication modes for the
authentication mode in which the command's settings are operable.
3.
If at least one of the following commands is set for a Switch, this command cannot be
set:
command.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Specify a character string that is no more than 32 characters. For details about
the characters that can be specified, see Specifiable values for parameters
(with the exception of the at mark (
We recommend that you use an upper-case letter for the first character.
command is set.
dot1x vlan dynamic enable
mac-authentication authentication
<List name>
aaa authentication
@
)).
mac-authentication
515
Advertisement
Table of Contents
