Dot1X Timeout Tx-Period - Alaxala AX1250S Software Manual

dot1x timeout tx-period

dot1x timeout tx-period

Sets the interval (in seconds) for sending EAP-Request/Identity packets when IEEE 802.1X
is valid.
Input format
To set or change information:
dot1x timeout tx-period
To delete information:
no dot1x timeout tx-period
Input mode
(config-if)
Parameters
<Seconds>
Set the interval (in seconds) for sending EAP-Request/Identity packets.
1.
2.
Default behavior
30 seconds is used as the interval for sending EAP-Request/Identity packets.
Impact on communication
None
When the change is applied

When the operating timer times out (the value of the timer becomes 0).

When the
authentication at the authentication level or the Switch level.
Notes
1. All IEEE 802.1X settings take effect when the
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3. The
port-control
4. Specify a value smaller than the one set by using the
command as the parameter value.
408
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 65535 (seconds)
clear dot1x auth-state
dot1x timeout tx-period
command has been set.
<Seconds>
operation command is executed to cancel
dot1x system-auth-control
command takes effect only if the dot1x
dot1x timeout reauth-period