Table of Contents
Advertisement
schedule-power-control system-sleep
Puts a Switch in the sleep state during scheduled power saving.
Putting the Switch in the sleep state reduces the amount of power consumed.
Input format
To set information:
schedule-power-control system-sleep
To delete information:
no schedule-power-control system-sleep
Input mode
(config)
Parameters
None
Default behavior
The Switch does not switch to the sleep state.
Impact on communication
All communications stop during scheduled power saving.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
The Switch does not switch to the sleep state during operation in configuration
command mode.
2.
To temporarily wake a Switch from the sleep state by forcing cancellation of sleep
mode, press the RESET switch on the front of the Switch continuously until all LEDs
on the front panel are on (three seconds or more). The Switch starts in scheduled
suppression mode. To return the Switch to the sleep state, use the
power-control schedule enable
schedule-enabled mode.
3.
Because the sleep state of a Switch is equivalent to its power-off state, information
that is not saved is not retained.
4.
If the sleep state continues for 20 days, the sleep state is canceled and the Switch is
started. After the Switch starts, it switches to the sleep state again.
5.
If this command is set, the Switch switches to the sleep state when the scheduled
execution time arrives. As a result, the following configuration command settings are
no longer valid:
schedule-power-control port-led
schedule-power-control port cool-standby
schedule-power-control system-sleep
operation command to switch to
set
61
Advertisement
Table of Contents
