Dot1X Vlan Dynamic Timeout Server-Timeout - Alaxala AX1250S Software Manual

dot1x vlan dynamic timeout server-timeout

dot1x vlan dynamic timeout server-timeout
Sets the time (in seconds) to wait for a response includes the time required for
retransmitting a response to an authentication server.
Input format
To set or change information:
dot1x vlan dynamic timeout server-timeout
To delete information:
no dot1x vlan dynamic timeout server-timeout
Input mode
(config)
Parameters
<Seconds>
Sets the time (in seconds) to wait for a response.
1.
2.
Default behavior
30 seconds is used as the time to wait for a response.
Impact on communication
None
When the change is applied

When the operating timer times out (the value of the timer becomes 0).

When authentication processing starts
Notes
1. All IEEE 802.1X settings take effect when the
command is set.
2. See Configuration commands and IEEE 802.1X authentication modes for the
authentication mode in which the command's settings are operable.
3. This command takes effect only if the
been set.
424
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 65535 (seconds)
<Seconds>
dot1x system-auth-control
dot1x vlan dynamic enable
command has