Exit - Alaxala AX1250S Software Manual

exit

exit
Returns to the previous mode. If you are editing data in config mode, configuration
command mode ends and administrator mode resumes. If you are editing data in
subcommand mode, you are returned to the next higher level.
Input format
exit
Parameters
None
Response messages
The following table describes the response messages for the
Table 3-2 Response messages for the exit command
Message
Unsaved changes would be lost when
the machine goes to sleep!
Do you exit "configure" without
save ? (y/n):
The machine is just going to
sleep! Do you exit ? (y/n):
Notes
Note the following if you use the
1. You can use the
without saving the configuration file to internal flash memory. Because the
configuration file at this time is still being edited, first edit the configuration file, and
then save it.
2. After editing the running configuration, if you execute the
saving the changes you made to internal flash memory, the startup configuration file
in internal flash memory and the running configuration will no longer be the same.
After editing the configuration, you must always save your changes.
Related commands
None
16
Description
When the following commands are configured, configuration
command mode will end without any changes being saved:
schedule-power-control system-sleep
schedule-power-control time-range
The configuration changes you made will be lost when the Switch
switches to sleep mode. Enter
exit
the command. If necessary, use the
the edited configuration.
If configuration command mode ends, the Switch will switch to
sleep mode.
y
Enter to switch to the sleep state. If you do not want to switch to
the sleep state, enter
(config)# $set power-control schedule
use the
disable
command to set the power saving schedule
functionality to suppression mode.
exit command in
exit command to temporarily exit configuration command mode
exit command.
y
to finish editing. Enter
save
n exit
to cancel the command, and then
config mode:
exit command without
n
to stop
command to save