Table of Contents
Advertisement
ip arp inspection limit rate
Sets the ARP packet reception rate (the number of ARP packets that can be received per
second) on the applicable port when the DHCP snooping functionality is enabled on a
Switch. ARP packets exceeding the reception rate are discarded.
Input format
To set or change information:
ip arp inspection limit rate
To delete information:
no ip arp inspection limit rate
Input mode
(config-if)
Parameters
<Packet/s>
Specify the number of ARP packets that can be received per second.
1.
2.
Default behavior
The reception rate has no limit.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
When the
inspection limit rate
rate
command become invalid. As a result, there is no limit on the reception rate for ARP
packets.
Related commands
ip dhcp snooping
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 300 packets/s
ip arp inspection trust
command is set, the settings of the
<Packet/s>
command is set on the port where the
ip arp inspection limit rate
ip arp
ip arp inspection limit
229
Advertisement
Table of Contents
