System L2-Table Mode - Alaxala AX1250S Software Manual

system l2-table mode

Sets a method for searching the Layer 2 hardware table.
Input format
To set or change information:
system l2-table mode
To delete information:
no system l2-table mode
Input mode
(config)
Parameters
<Mode>
Selects the method for searching a table used for registration in the hardware table.
1.
2.
1 to
auto
Default behavior
1 is set as the method for searching the table.
Impact on communication
Because the Switch has to be restarted, communication via the Switch stops until the restart
process is complete.
In auto-selection mode, frame forwarding and incoming communication stop temporarily
when the table search method is changed.
When the change is applied
If you have changed any values, save the configuration and restart the Switch. The new
setting values take effect when the Switch is restarted.
Note that if the form of the command changes to
is restarted, the operational table search becomes 1.
<Mode>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
5
Sets the value that specifies the method used to search the Layer 2 hardware
table.
Sets the auto-selection mode.#
Note: Auto-selection mode
If a hash entry overflow occurs due to a hash conflict in the hardware table, the
search method for the hardware table is changed automatically.
no system l2-table mode
system l2-table mode
and the Switch
51