Ip Access-List Standard - Alaxala AX1250S Software Manual

ip access-list standard

Sets the access list that operates as an IPv4 filter. There are two types of access lists that
operate as IPv4 filters. One type is an IPv4 address filter and the other type is an IPv4
packet filter.
This command sets an IPv4 address filter.
An IPv4 address filter filters packets based on IPv4 address.
Multiple filter conditions can be set by using a single access list ID. For an Ethernet interface
and a VLAN interface, a maximum of 127 filter conditions can be set. For a Switch, a
maximum of 1024 access lists (for IPv4 and MAC) can be created. A maximum of 1024 filter
condition entries can be created.
Input format
To set or change information:
ip access-list standard
To delete information:
no ip access-list standard
Input mode
(config)
Parameters
<ACL ID>
Sets the identifier of the IPv4 address filter that is to be set.
The Switch enters config-std-nacl mode.
Names that have already been used for IPv4 packet filters and MAC filters cannot be
set.
1.
2.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Set 3 to 31 characters, the first character of which must be a non-numeric
character. For details about the characters that can be specified, see
Specifiable values for parameters.
<ACL ID>
<ACL ID>
ip access-list standard
297