Table of Contents
Advertisement
qos (mac qos-flow-list)
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
If
nnnn.nnnn.nnnn ffff.ffff.ffff
destination address,
2.
If a protocol name is set for the destination address or if the address of a protocol
name that can be set is set, the protocol name is displayed. For details about the
address of a protocol name that can be set as the destination address, see Table
20-8 Destination MAC address names that can be specified. If
0000.0000.0000
the destination address,
3.
When
same time, the user priority is replaced with the value set for
4.
Because the parameters set by using this command are valid only for relay packets,
they are not valid for incoming and outgoing packets. Therefore, the set parameters
are not valid for incoming and outgoing packets.
Related commands
mac qos-flow-list
mac qos-flow-group
mac qos-flow-list resequence
remark
348
any
is displayed.
is entered as the source address in cases other than the above and
host nnnn.nnnn.nnnn
and
cos
replace-user-priority
is entered as the source address and the
is displayed.
are set for the
action
nnnn.nnnn.nnnn
parameter at the
.
cos
Advertisement
Table of Contents
