Mac-Authentication Static-Vlan Force-Authorized - Alaxala AX1250S Software Manual

mac-authentication static-vlan force-authorized

mac-authentication static-vlan force-authorized
When the RADIUS authentication method is used, this command forcibly changes the
status of a terminal that requests authentication on the applicable port to authentication
authorized if the RADIUS server does not respond or a request to the RADIUS server fails
because of a route failure or other problem.
Input format
To set or change information:
mac-authentication static-vlan force-authorized [action trap]
To delete information:
no mac-authentication static-vlan force-authorized
Input mode
(config-if)
Parameters
[action trap]
When forced authentication is authorized, private traps are issued.


Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All MAC-based authentication settings take effect when the
system-auth-control
2. See Configuration commands and MAC-based authentication modes for the
authentication mode in which the command's settings are operable.
3. Be especially careful when using this functionality, as it can pose a security problem.
4. This command is enabled when the following condition exists:

542
Default value when this parameter is omitted:
Private traps are not issued if forced authentication is authorized.
Range of values::
action trap
command is set.
All the following configurations have been set:
- radius-server host
mac-authentication port
-
or mac-authentication radius-server host
#1
mac-authentication