Table of Contents
Advertisement
channel-group lacp system-priority
channel-group lacp system-priority
Sets the LACP system priority of a channel group for link aggregation.
Input format
To set or change information:
channel-group lacp system-priority
To delete information:
no channel-group lacp system-priority
Input mode
(config-if)
Parameters
<Priority>
Sets the LACP system priority. The lower the priority value, the higher the priority.
1.
2.
Default behavior
The setting of the
Impact on communication
If a priority is set for the operating channel group, the channel group goes down, and then
restarts.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
This command is effective only when LCAP-based link aggregation is used.
2.
If the LACP system priority is changed, the status of all ports registered for the
channel changes to
Related commands
interface port-channel
102
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 65535
lacp system-priority
Blocking
<Priority>
command is used.
(communication interrupted).
Advertisement
Table of Contents
