Table of Contents
Advertisement
ethernet cfm cc enable
Sets the MA which uses CC in the domain.
If the
ethernet cfm mep
to CCM starts.
Input format
To set information:
ethernet cfm cc level
To delete information:
no ethernet cfm cc level
Input mode
(config)
Parameters
level
<Level>
Sets the domain level that has been set by using the
command.
1.
2.
ma
<No.>
Sets the MA ID number that has been set by using the
vlan-group
VLAN ID by using the
1.
2.
Default behavior
Monitoring by CC is not performed.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
command has already been set, sending from the applicable port
<Level>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
0 to 7
command. If the MA name has been set by using a character string or a
ma name
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
0 to 65535
ma
<No.>
enable
<Level>
ma
<No.>
enable
command, the parameter sets the MA ID number.
ethernet cfm cc enable
ethernet cfm domain
ma name
command or the
ma
601
Advertisement
Table of Contents
