Table of Contents
Advertisement
dot1x vlan dynamic timeout reauth-period
dot1x vlan dynamic timeout reauth-period
Sets the interval (in seconds) for re-authenticating a supplicant after a successful IEEE
802.1X authentication. EAP-Request/Identify packets for re-authentication are sent to a
supplicant at the interval set by using this command as a prompt for supplicant
re-authentication.
Input format
To set or change information:
dot1x vlan dynamic timeout reauth-period
To delete information:
no dot1x vlan dynamic timeout reauth-period
Input mode
(config)
Parameters
<Seconds>
Sets the interval (in seconds) for re-authenticating a supplicant.
1.
2.
Default behavior
3600 seconds is used as the interval for re-authenticating a supplicant.
Impact on communication
None
When the change is applied
When the operating timer times out (the value of the timer becomes 0).
When the
authentication at the authentication level or the Switch level.
When a terminal is authenticated successfully at the authentication level when there
are no authenticated terminals.
Notes
1.
All IEEE 802.1X settings take effect when the
command is set.
2.
See Configuration commands and IEEE 802.1X authentication modes for the
authentication mode in which the command's settings are operable.
3.
This command takes effect only if the
been set.
422
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 65535 (seconds)
clear dot1x auth-state
<Seconds>
operation command is executed to cancel
dot1x system-auth-control
dot1x vlan dynamic enable
command has
Advertisement
Table of Contents
