ftp-server
ftp-server
Permits FTP access from remote operation terminals. To set the IPv4 address of a remote
operation terminal to permit or deny logging in to a Switch, set a common access list that is
shared by Telnet access in config-line mode.
Input format
To set information:
ftp-server
To delete information:
no ftp-server
Input mode
(config)
Parameters
None
Default behavior
Does not accept remote access that uses FTP.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
When an access list has been configured in config-line mode, the IPv4 addresses of remote
operation terminals for which logging in to a Switch using FTP is permitted or denied are
restricted according to the same access list.
Related commands
line vty
ip access-group
10