Table of Contents
Advertisement
name
name
Sets a string that identifies the regions of multiple spanning trees.
Input format
To set or change information:
name
To delete information:
no name
Input mode
(config-mst)
Parameters
<Name>
Sets the character string used to identify a region.
1.
2.
3.
Default behavior
Null
is set for
Impact on communication
When
mst
interrupts communication until the topology is formed.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
spanning-tree mst configuration
150
<Name>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Specify a character string that is no more than 32 characters. For details about
the characters that can be specified, see Specifiable values for parameters.
Notes on using this parameter:
To configure the same MST region, the values for this parameter and the
revision
parameter, as well as those of the MST instance ID and the VLAN ID
set by the
vlans
parameter, must match within the MST region.
name
.
is set for the
spanning-tree mode
command, recalculation of the topology
Advertisement
Table of Contents
