Table of Contents
Advertisement
lacp port-priority
lacp port-priority
Sets the port priority.
Input format
To set or change information:
lacp port-priority
To delete information:
no lacp port-priority
Input mode
(config-if)
Parameters
<Priority>
Sets the port priority. The lower the priority value, the higher the priority.
When
When
1.
2.
Default behavior
128
is set as the port priority.
Impact on communication
If you set the port priority for the operating port by setting
, communication is temporarily interrupted. If you set the port priority for the
passive
operating port by setting
standby link functionality, and communication might temporarily stop.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
If you set the
max-active-port
2.
If you change <Priority>, the status of the applicable port changes to
(communication interrupted).
110
<Priority>
is set for the
on
channel-group mode
This parameter is used for selection of the standby link with the
max-active-port
command.
or
is set for the
active
passive
This parameter is applied to the port priority of the LACP protocol.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
0 to 65535
channel-group mode
max-active-port
for the destination device.
command
channel-group mode
channel-group mode
to
on
, the port in use is changed by the
command, match its setting to the setting of
command
to
or
active
Blocking
Advertisement
Table of Contents
