4. Installing a Switch
4.6 Connecting and disconnecting the power cable
4.6.1 Replacing the bracket preventing disconnection of the power cable
(when a 200 V AC power cable is used)
The bracket attached when a Switch is shipped from the factory supports only the
supplied power cable.
To connect the optional 200 V AC power cable to a Switch, use the bracket supplied
with the power cable.
NOTE
(1) Removing the bracket preventing disconnection of the power cable
Pull the bracket outward from support B to remove it, and then pull the support A
side.
Figure 4-20 Removing the bracket
(1) Bracket preventing disconnection of the power cable
(2) Support A
(3) Support B
NOTE
(2) Attaching the bracket
Insert the bracket into support A, and then pull the bracket of the other side away
from support B and insert it.
106
If you have obtained your own 200 V AC power cable, do not use the
bracket.
Keep the removed bracket with the power cable.